Arduino MATERIA 101 Bedienungsanleitung PDF herunterladen (Seite 32)

Assembly Manual

Arduino Materia 101

assEmBlINg ThE fRamE

Fig. 2

Mount the frame and the D6 bearings

using pressure, from inside to outside,

into the holes on the inside ears to

the frame, as pictured. For better

assembling, just use hand pressure

on the bearing and then with pliers,

move the bearing inside the hole.

Careful not to break the bearing.

Fig. 3

Couple the metal rod guides and fasten

them on the Z axis guides holes with

M3x6 bolts (2) as you did in chapter 3.

Fig. 4

Get the 6mm bars (2) and pulleys (5).

Starting with the rear bar, locate

the entrance hole and insert the bar

until it passes just to the first yellow

bearing and stick it in three pulleys

according to the orientation shown in

the picture. Before you slide the bar

up to the second bearing, insert the

belts in this order: long, short, long,

laying them on the respective pulleys.

Start placing the grub screws within

the pulley’s threaded holes without

tightening them.

Fig. 5

Move on to the D6 front bar. Locate

the entrance hole and insert half

of the bar. Insert the two pulleys,

orienting them, as pictured, and pass

the two belts inside the bar, laying

them on the respective pulleys. Also

here, place the M3 grub screw in

the pulleys threaded holes without

tightening.

Fig. 2

Fig. 4

Fig. 3

Fig. 5

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 54 55

Kommentare zu diesen Handbüchern

Keine Kommentare

Arduino MATERIA 101 Bedienungsanleitung Seite 32

Kommentare zu diesen Handbüchern