Arduino MATERIA 101 Bedienungsanleitung PDF herunterladen (Seite 26)

Assembly Manual

Arduino Materia 101

assEmBlINg X caRRIagE aND

ThE EXTRuDER

Fig. 6

Take the M3x40 bolts. Align the fan

with the stepper motor and then the

connector with the cable on the same

side. Fasten the fan with the screw then

repeat the same operation with the 5mm

stand-offs and screw the fan on the

stepper motor’s back, as in the picture.

Fig. 7

Now attach the extruder block to

the stepper motor, which helps keep

the connector facing upward, with

M3x25 bolts (4). Make sure to leave

the springs on the left side. Place the

wiring support plate on the right. The

extruder block orientation is crucial;

before proceeding further please make

sure it is correct as in the photo. The

bearing adjustment screws should

be on the left. Once mounted this

part should be accessible when it is in

“home” position.

Fig. 8

You should have saved 4 nylon bearing

supports. Cut away the extra with

scissors from two of those four as

seen in the picture.

Fig. 9

Tighten the nylon bearing carrier with

M3x6 bolts (4) onto the carriage. This

part must be positioned on the back

of the carriage leaving the cut part on

the inner side.

Fig. 6

Fig. 8

Fig. 7

Fig. 9

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 54 55

Keine Kommentare

Arduino MATERIA 101 Bedienungsanleitung Seite 26